Skip to content

Diode Dynamics Rear Turn Signal LEDs For 4Runner (2010-2024)

1 review
$59.90
In Stock

Features

  • Modern LED appearance with instant on and off
  • Direct replacement for Toyota 4Runner rear turn bulbs
  • Plug and play, no modification with factory 7440 bulb size
  • Multiple brightness levels are available

Overview

LED Indicators. The factory incandescent turn signals on the Toyota 4Runner illuminate in a slow glow, taking a moment to turn off and on. With replacement LED bulbs, you can immediately update your vehicle with the instant on-off blinking of modern LEDs. This instant activation adds a modern and distinct look to the 4Runner.

Brightness. All Diode Dynamics LED lighting is rated with accurate, measured lumen figures, not calculations or guesses. We test the true output in-house and provide you the real numbers to compare.

Amber Rear Turn Comparison

Correct Color. You'll see that we offer both a red and amber option, which meets SAE/DOT "amber" and "red" requirements. If you have a clear lens or an amber reflector over the turn signal bulb on your 4Runner, amber is the correct emitter color for maximum turn signal output. If your vehicle has a red lens over the rear turn signal, then red is the correct emitter for you.

Reduced Load. When it comes to LED upgrades, you'd think the lower power draw would be a great feature! However, the 4Runner looks for a specific power draw from the turn signals. LEDs will make the vehicle think a bulb has gone out, due to a lower power draw. This causes a "hyperblink," or fast-blinking turn signal, which can be corrected with LED Resistors or an LED Flasher.

The most basic, tried-and-true method to correct hyperblinking is to add resistors. Since a 6-ohm resistor uses about the same power as a standard turn signal bulb, these can be used on any vehicle, but do require tapping factory signals. One resistor is needed to replace each turn signal bulb.

You may have also heard of flasher relays, which is the actual module that determines flash speed. On some vehicles, it can be replaced with one that is designed for LED power levels. However, on many newer vehicles, these modules cannot be replaced. If it's possible to replace the flasher on the 4Runner, you'll see the one listed above. Only one flasher is needed per vehicle, for both front and rear LED turn signal conversions.

Reliability. Diode Dynamics LEDs are built with constant-current inductive circuitry, along with transient suppression. They are tested by our engineering team with a device that replicates years of voltage spikes, like the ones generated each time the alternator starts and stops on your 4Runner. This is what kills most LED bulbs over time, but just like factory components, Diode Dynamics LEDs are designed with built-in circuit protection. While more expensive than simple bulbs, this allows Diode Dynamics LEDs to last for years, with no flickering or failure.

Experience. After over a decade in business, Diode Dynamics is one of the most trusted names in automotive LED lighting. We directly assemble and engineer an increasing number of products in the United States, allowing for higher quality and performance, with the newest and brightest LED technology. Whether it's a Toyota or anything else, we pride ourselves in offering only the best possible LED solutions. Please contact us if you'd like to discuss your lighting project!

Bulb Options

7440 HP48 - 

  • 48 LEDs in omnidirectional design.
  • Diffusing cover for even output and clean appearance when off.
  • Molded connector with sturdy terminals.
  • Cosmetic upgrade only.
  • 250 lumens per bulb.

7440 HP11 - 

  • Four COB-type LED with a single high-power chip mounted at the top.
  • Full metal heatsinking for reliable operation.
  • Nonpolar and CK compatible electrical design.
  • 310 lumens per bulb.

7440 XP80 - 

  • Sixteen high-power 5W LEDs are arranged in all directions.
  • Metal heatsink to maintain high output.
  • Inductive constant-current drive circuit.
  • 510 lumens per bulb.

What's Included

Quantity: Two (2)
 
Warranty: 3-year warranty
 
Return Policy: 30-day Return with no restocking fee
 
100% Satisfaction Guarantee

Fitment

Bulb Size: 7440
 
Application: Rear Turn Signal
 
Make: Toyota
 
Model: 4Runner
 
Years: 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024
 
Flasher Setup: BCM Controlled (resistor only)
Customer Reviews
5.0 Based on 1 Reviews
5 ★
100% 
1
4 ★
0% 
0
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Write a Review Ask a Question

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
DE
01/12/2023
Duncna E.
United States

Good and bright

Easy install and adds more punch to the signal.